LED floodlight is a uniform point of light in all directions to the point of light, the scope of its irradiation can be adjusted to illuminate the role of the entire scene.

LED floodlight appearance structure: shell aluminum alloy forming, LED Flood Light the surface of anti-oxidation anti-corrosion treatment

1. Luminous flux: 3000-3300Lm

2. Working voltage: AC 85-265V

3. Internal constant current module, LED Flood Light constant current output 930mA, voltage 32V.

4. Beam: (6 meters) Beam diameter of 3.3 meters

5. Illumination: (6 m) for 40 LUX

6. Light source life: 50,000 hours or more

7. Circuit life: to ensure that more than 3 years

8. Material: green high-pressure die-casting aluminum alloy lamp shell

9. Dustproof and waterproof rating: IP65 ~ IP68 Po micro respirator

10. Efficiency> 90%

Although the LED floodlight is easy to install, but some of the installation techniques and need to pay attention, this is the addition of the advantages of LED floodlights. The installation of lamps with fixed screws, the installation is relatively simple, elaborate: the need to use the material: LED guardrail light clip, LED Flood Light with waterproof function of the transformer, sub-controller, the steps are as follows:

1, the installation of fence, drilling in the wall, arduous according to the actual requirements, usually within 3 cm,

2, do anti-static measures, such as workstations to ground, LED Flood Light the workers wear the corresponding static clothing, anti-static measures, because different grades of LED floodlight quality, antistatic ability of different strength.

3, the installation of attention to sealing, poor sealing, diameter LED floodlights affect the service life

4, LED flood light wiring is best not more than 25 cm, the transformer power can be a corresponding variable length, or affect the brightness

LED floodlight installation precautions

1, try to use the series LED form, because LED floodlight voltage difference is special. Ordinary LED peak current is maintained at 80 mA, the reverse voltage in the 6V up and down, in the LED application should pay attention to the design of the circuit when the peak voltage and current in this limit

2, the use of welding under the voltage of 25 watts, the soldering iron alone control hey 300 degrees Celsius in the high temperature under the exposed SMD LED, do not squeeze its epoxy part, LED Flood Light or wipe with a sharp object, because the LED lamp is very Fragile, easily damaged, welding time 3 seconds. In the case of

LED floodlights are widely used, so the installation of tips and precautions is very important, LED is a new light source, in the correct installation mode, LED Flood Light to ensure that LED floodlights stable long normal work