LED heat pipe lamp includes lamp, lamp and LED light source module; The inner wall of the lamp is coated with a layer of heat dissipation film, and the LED light source module is installed on the inner wall of the lamp tube along the lamp length direction; Heat Pipe LED High Bay Light the lamp holder is sheathed at both ends of the lamp tube, which is connected with the lamp through a high thermal conductivity adhesive, which is composed of a shell, an insulating plate and a lamp foot, and the bottom of the shell is a circular bottom, Heat Pipe LED High Bay Light and a side wall is extended in the same direction along the edge of the rounded bottom, The insulating plate is fixed on the inner wall of the circular bottom and the insulating plate seals the hole of the round bottom, Heat Pipe LED High Bay Light the lamp foot passes through the insulating board and extends outward, and the LED light source module is connected with the lamp foot through the wire; it has simple structure, convenient use and long service life, etc.
What is the characteristic of LED heat pipe lamp?
1: Environment-friendly lamps
2: Less heating phenomenon
3: No noise
4: Eye protection
5: No mosquito troubles
6: Voltage Adjustable
7: Province Electric Life long
8: Strong and secure
9: Good versatility
10: Colorful
Overview of LED heat pipe lamps
(a) improved LED chip, package structure and materials--the upper midstream industry completed
(b) System integration, mainly for the lamp cooling mode, Heat Pipe LED High Bay Light improve heat transfer power-thermal design work
3. Analysis of the cooling structure of LED lamps
Chip (node temperature control in the "85 ℃")-(heat resistance of small products are conducive to heat)-light bead substrate-aluminum substrate (increase in copper covered area for heat conduction)-(using thermal conductivity silicone)-radiator shell lamp (good structure for air convection)--ambient
Heat Pipe LED High Bay Light The advantages of using FPC dimmer are: Low dimming cost, compatible with existing lines, no need for rewiring and dimming after cutting. The disadvantage is that FPC dimming performance is poor, Heat Pipe LED High Bay Light usually resulting in reduced dimming range, and will result in a minimum required load exceeding a single or a small amount of LED lights rated power. Because of the properties of the SCR half control switch, only the function of opening current, and can not completely shut down the power flow, even if the minimum is still weak current through, and led micro-current luminescence characteristics, Heat Pipe LED High Bay Light so that a large number of SCR dimming led still has a weak glow of the phenomenon, become the current cable-free led dimming way to promote the problem.
