With the emergence of LED grow lights, the development of indoor planting is now faster and faster. But how to make the planting effect better, this is a problem that people are more concerned about. Today, I will make a good planting effect on how to install it correctly.
1. Illumination distance
The lighting distance of LED grow lights is very important. You should adjust the points for different plants at different stages, and you must also unify the distance to make the light even more uniform. If the distance is not well controlled, it may harm the growth of plants. The general recommendation is that the germination stage distance: 60 cm, the seedling stage distance: 75 cm, the growth stage distance: 45 cm, and the flowering stage distance: 30 cm.
2. Evenly distributed installation
Measure the floor area. Multiply the length by the width to get the square meters of the planting area. You can make the right choice based on how much power to provide per square meter, that is, how many LED grow lights are installed per square meter. In this way, each lamp can be evenly distributed, so that the outer edge will receive strong light, so that the light will be more uniform, and the growth of plants will be more effective.
Installation method and method of yaorong LED grow light
1. A mounting bracket
1. Installation of the triangle bracket: Take out the triangle bracket from the packing box, open the support feet of the bracket, and extend the support rod to complete the installation.
2. Install the LED grow light: fix the screw under the LED grow light on the top of the bracket, rotate the tripod support rod, tighten the fixing parts, and the installation is complete.
Two, B mounting bracket
1. Mounting bracket: Take out the mounting bracket and mounting accessories from the packing box, insert the round iron piece from the bottom of the steel pipe (higher than the round hole under the steel pipe), insert the pin into the round hole under the steel pipe, and fix the round iron piece. Finally, rotate the mounting bracket into the soil as a whole (the round iron sheet should be close to the ground or buried in the soil).
2. Install LED grow lights.
Remove the screw on the plant growth light, fix the top end of the LED grow light on the upper end of the horizontal bracket, turn the screw, tighten the fixing piece, and complete the installation.
Three, C mounting bracket
1. Mounting bracket: Take out the mounting bracket from the packing box, connect the two long steel pipes together and rotate and tighten, insert the horizontal bracket from the top of the connected steel pipe, adjust the height according to the height of the plant and tighten it, from the bottom of the connected steel pipe (high Insert the round iron piece into the round hole under the steel pipe, insert the pin into the round hole under the steel pipe, fix the round iron piece, and finally rotate the mounting bracket into the soil (the round iron piece should be close to the ground or buried in the soil) ).
2. Install the LED grow light: remove the screw on the plant growth light, fix the top of the LED grow light on the upper end of the horizontal bracket, turn the screw, tighten the fixing piece, and complete the installation.
3. Power access mode.
Connection method 1: Insert the power cord connector into the power port of the growth lamp (pay attention to the connection of the interface bayonet when inserting), tighten the nut on the power cord, and plug the other end of the power socket directly into the AC220 power socket.
Connection method 2: Insert the power cord connector into the power port of the LED grow light and tighten it. The red wire at the other end of the power supply is the live wire; the blue wire: the neutral wire; the yellow wire: the ground wire is connected to the AC220 power supply. When the power is turned on, the LED grow light works normally.
Therefore, when installing the LED grow light, the light distance should not be too far or too close. At the same time, the installation of the LED grow light should be arranged according to the size of the space. Correct installation is a prerequisite for good results.
